Engine Idle/ Stalls
Thread Starter
Junior Member
Joined: Oct 2010
Posts: 4
Likes: 0
Car: 1991 Camaro Z28 Convertable
Engine: 305
Engine Idle/ Stalls
Hello all 3rd gen camaro fans. This is my first post as I am new to this.
I have a 1991 camaro Z28 convertible, 5.0 MPI that I have owned since 1993.
My problem is, all of a sudden, the car is hard to start. when it does start,it idles. if I press on the accelerator the rev goes up a few rpms then stalls. I will do that a few times and then it wont start at all. after a couple of days I can start the procedures allover again. Hopefully someone has had the same problem and could help me out. It would be most appreciated. I hooked up a scanner/code reader and it showed NO codes.
Thanks,
Michael
I have a 1991 camaro Z28 convertible, 5.0 MPI that I have owned since 1993.
My problem is, all of a sudden, the car is hard to start. when it does start,it idles. if I press on the accelerator the rev goes up a few rpms then stalls. I will do that a few times and then it wont start at all. after a couple of days I can start the procedures allover again. Hopefully someone has had the same problem and could help me out. It would be most appreciated. I hooked up a scanner/code reader and it showed NO codes.
Thanks,
Michael
Senior Member
Joined: Jul 2009
Posts: 523
Likes: 103
From: Morgantown, WV
Car: 1990 Trans Am
Engine: 5.7 350 HSR afr195 xfi268
Transmission: T5
Axle/Gears: 3.08 posi
Re: Engine Idle/ Stalls
Probably need to know if your timing and fuel pressure have been checked? Anything changed or added before this started?
Thread Starter
Junior Member
Joined: Oct 2010
Posts: 4
Likes: 0
Car: 1991 Camaro Z28 Convertable
Engine: 305
Re: Engine Idle/ Stalls
Nothing has been changed. It just started having that problem. I can hear the fuel pump prime. Ill have to check the fuel pressure.
Thanks for your input.
Michael
Thanks for your input.
Michael
Thread
Thread Starter
Forum
Replies
Last Post
89irocz355
Engine/Drivetrain/Suspension Parts for Sale
26
Sep 12, 2016 01:28 PM
'91CamaroRS
Transmissions and Drivetrain
5
Mar 29, 2016 06:42 PM




