Intake Manifold To China Wall Gap?
Thread Starter
Supreme Member
Joined: Sep 1999
Posts: 3,004
Likes: 813
From: Colorado USA
Car: '83 Firebird (T/A Clone)
Engine: 350 with L-69 components
Transmission: 700R-4, 2000 RPM stall converter
Axle/Gears: 10-bolt/3.73 ..
Intake Manifold To China Wall Gap?
How much of a gap is there supposed to be between the intake manifold ends and the top of the "China walls"?
With no gaskets, I have pretty much none, and with the gaskets, about 1/16" (basically the gasket thickness uncompressed)...
With no gaskets, I have pretty much none, and with the gaskets, about 1/16" (basically the gasket thickness uncompressed)...
Thread Starter
Supreme Member
Joined: Sep 1999
Posts: 3,004
Likes: 813
From: Colorado USA
Car: '83 Firebird (T/A Clone)
Engine: 350 with L-69 components
Transmission: 700R-4, 2000 RPM stall converter
Axle/Gears: 10-bolt/3.73 ..
Re: Intake Manifold To China Wall Gap?
Thanks...
Joined: Sep 2003
Posts: 25,895
Likes: 429
From: Pittsburgh PA
Car: 89 Iroc-z
Engine: 555 BBC Turbo
Transmission: TH400
Axle/Gears: MWC 9” 3.00
Re: Intake Manifold To China Wall Gap?
Ive seen abit more gap than that with gaskets but good black rtv or rightstuff seals anything.
Thread
Thread Starter
Forum
Replies
Last Post