Some one along the line mentioed some bits that could be used for porting heads with a Dremel. They were a smaller diameter shaft than the die grinder bits. Anyone know?

Anyone ported with a dremel? Thoughts?

 

i'd buy or barrow a die grinder and some carbide bits before i tried with a demeral

 

the dremel would be good for little stuff. I plan on using a die grinder but then again I have access to an air compressor.

 

Niether do I.

Just, bumping it up in hopes someone knows a cartrige cutter for the Dremel.

Pleez!!!:hail:

 

I used a carbide bur in my dremel with the cable. I ported both heads, intake, runners, and plenum with 1 bit. I got it at a farm store near me for less than 20.00. Dremels are just as fast as the die grinders , and a LOT less noise. Check some industrial supply hardware stores for the carbide bits they work much better than stones.