Part #'s needed for intake bolts...
Thread Starter
Member
Joined: Feb 2003
Posts: 205
Likes: 0
From: TEXAS
Car: 1987 Monte Carlo SS
Engine: 5.7L TPI
Transmission: 4 spd auto
Part #'s needed for intake bolts...
Hi, I need access to my EGR stuff but alot of the torx bolts that hold the runners to the plenum are nearly stripped (probably from a previous owner using allen instead of torx 
). I'd like to just put it back together with new bolts instead of stripping them out completely during reassembly. Also, The one of the long 10mm bolts that hold the TB to the plenum is nearly stripped too and I'd like to replace those too. Anyone have part #'s for these bolts?
Also part #'s for the plenum/runner gaskets would be helpful too.
Thanks...
). I'd like to just put it back together with new bolts instead of stripping them out completely during reassembly. Also, The one of the long 10mm bolts that hold the TB to the plenum is nearly stripped too and I'd like to replace those too. Anyone have part #'s for these bolts?Also part #'s for the plenum/runner gaskets would be helpful too.
Thanks...
Joined: Aug 1999
Posts: 858
Likes: 6
From: Elkton MD, USA
Car: 1985 Camaro Z28, VIN F
Engine: 427 sbc, HSR
Transmission: T-56, self rebuilt 700+ hp
Axle/Gears: Moser 12bolt, 3.42 trutrac
YearOne:
http://www.yearone.com/serverfiles/p...G&hid=G13AT127
or I'm sure any of the parts sponsors of
thirdgen.org will have used sets. (flashing
ads on the top of every page)
mike
http://www.yearone.com/serverfiles/p...G&hid=G13AT127
or I'm sure any of the parts sponsors of
thirdgen.org will have used sets. (flashing
ads on the top of every page)
mike
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
