I was wondering if Im not going to run emmisions on my car if I can just fab a plate to go where the egr goes. Not to sure on the whole set-up. If not what do I have to do with it??

 

yea, they make EGR block off plates, and im not sure but the intake might come with one... check with SDPC.

 

I ordered the intake from them and already recieved it. It doesnt come with a block off. So do I just make one and block it off and its then just forgotten about, or is there anything else I will need to do?

 

i bought the same intake and i was wondering that also.......and something else i was wondering about is the other egr port where the tubes from my new headers go....it goes from the side of the intake to the small tubes on top of the header, scpc wants 70 bucks for the hose and setup.....my new chip will have the egr turned off ...so i was wondering if i could make a plate for that on too?......thanks

 

i know tpis sells the block off plates for both sides intake and exhaust.they realy easy to make.just fab some up and you should be rippin.eric

 

thanks eric for the much needed advice............