HP estimate, and Lots 'O Questions
Thread Starter
Joined: Jan 2001
Posts: 2,120
Likes: 18
From: Quakertown, PA
Car: 1992 Camaro Z28 Convertible Z03
Engine: 383 SuperRam
Transmission: 700R4
Axle/Gears: 2.73
HP estimate, and Lots 'O Questions
What you think it will put out, I'll be building it this winter
L98 Block, Possibly stock Crank
bored .30 over, 5.7 Rods, hypereutectic Pistons
roller lifters, hardened pushrods, roller rockers (1.5), ZZ9 cam, L98 heads ported & polished, TPI (Ported, Polished, Siamesed)
Think it could handle a turbo some day, or nitrous.
I know I wouldnt want to do the turbo or nitrous with it, but how would I raise compression, and how much power would it add, deck the heads? will the valves hit. Yes I know, a LOT of questions
L98 Block, Possibly stock Crank
bored .30 over, 5.7 Rods, hypereutectic Pistons
roller lifters, hardened pushrods, roller rockers (1.5), ZZ9 cam, L98 heads ported & polished, TPI (Ported, Polished, Siamesed)
Think it could handle a turbo some day, or nitrous.
I know I wouldnt want to do the turbo or nitrous with it, but how would I raise compression, and how much power would it add, deck the heads? will the valves hit. Yes I know, a LOT of questions
Member
Joined: Aug 2003
Posts: 459
Likes: 0
From: The Cheese Head State - GO PACKERS!
Car: 86 "Ram Air" IROC
Engine: 305 5.Slow
Transmission: 700R4
a stock motor can hold up to a turbo or nitrous, just depends on how much nitrous and how many LBS of boost you use on the turbo.
Thread
Thread Starter
Forum
Replies
Last Post