Another Time question
Thread Starter
Member
Joined: Jan 2003
Posts: 385
Likes: 0
From: North West Indiana
Car: 2001 Silverado (I miss my 3rd gens)
Engine: 4.8
Transmission: 4L60E
Another Time question
I know I know, but I would like to get an estimate for 1/4mile times for my IROC.
Now before I start, I know I shoulda gone w/ a 350, but I had to buy tools for work and the budget was low so, here it is.
86 IROC
LB9 bored .30 over
Cam: Summit racing TPI cam
Duration @.050 204 in/ 214 ex.
Gross valve lift: .420in/442 ex.
Heads:
Stock LB9, port/polished w/ new springs
3 angle valve job.
Stamped roller rockers
Intake:
Stock ported to match heads
Exhaust:
1 5/8 primary shorty headers
gutted cat
3" flowmaster delta series catback
Trans:
Rebuilt 700 R4
3.23 limited slip rear
I would just like to get an estimate for times I would run.
Thanks for any input.
Now before I start, I know I shoulda gone w/ a 350, but I had to buy tools for work and the budget was low so, here it is.
86 IROC
LB9 bored .30 over
Cam: Summit racing TPI cam
Duration @.050 204 in/ 214 ex.
Gross valve lift: .420in/442 ex.
Heads:
Stock LB9, port/polished w/ new springs
3 angle valve job.
Stamped roller rockers
Intake:
Stock ported to match heads
Exhaust:
1 5/8 primary shorty headers
gutted cat
3" flowmaster delta series catback
Trans:
Rebuilt 700 R4
3.23 limited slip rear
I would just like to get an estimate for times I would run.
Thanks for any input.
Thread
Thread Starter
Forum
Replies
Last Post
