Hey all,
I'm trying to figure out the best way to run braided fuel lines for my LB9. I have an '88 serpentine belt setup, and I'm trying to route around it cleanly. Anyone have pics or suggestions?

 

I am looking for pics of the same thing but for an 85 V-belt set up.

 

Try Pure Choice Motorsports at www.performanceplumbing.com They sell a -6AN braided hose kit with adapter fitting for TPI's

 

I had a shop make some 180 degree bends, and hooked them to my hard lines. Then, ran braided to the fuel rails. Not sure how well you can see them, so I'll throw in a couple pics, one of the 180's, and one of the engine.. I routed along the fenderwell, but went too high over the brake booster. Then under the wiper motor, and bent to the rails. Don't know if it helps, but it's the way I did it.

 

And some of the routing. It will fit behind the distributor cap. And it is 6-AN size hose.