How hard to install ASP underdrive crank pulley

Reply Subscribe

Thread Tools

Search this Thread

Feb 19, 2005 | 11:31 AM

NiceTry

Thread Starter

Junior Member

Joined: Jan 2003

Posts: 28

Likes: 0

From: Clarksville, TN

How hard to install ASP underdrive crank pulley

I have this thing laying around, and thought about doing it today? Are there any write-ups on it anywhere? Any special tools needed like a crank pulley puller, etc.? Also, the car has no smog equipment on it, so what size belt will I need afterwards?

BTW, this is going on a 91' Z 355 TPI.

Feb 19, 2005 | 02:09 PM

kevinc

Supreme Member

Joined: May 2000

Posts: 2,963

Likes: 3

Car: 1982 Z28

Engine: LS1

Transmission: T56

Re: How hard to install ASP underdrive crank pulley

Quote:

Originally posted by NiceTry
I have this thing laying around, and thought about doing it today? Are there any write-ups on it anywhere? Any special tools needed like a crank pulley puller, etc.? Also, the car has no smog equipment on it, so what size belt will I need afterwards?

BTW, this is going on a 91' Z 355 TPI.

If you have an AutoZone nearby you can borrow a balancer remover and balancer installer...two separate tools in most cases.

Not a very hard project for most people, but it depends on skill level. Easy to really damage your crank if you screw up and run the remover into your crank threads.