MAT
Thread Starter
Member
Joined: Feb 2001
Posts: 464
Likes: 0
From: Lenhartsville, PA
MAT
Is it really worth relocating the MAT without proper PROM adjusting. I have a SD setup and I don't have the burning equipment yet. So for now, should I just leave it alone?
------------------
'88 IROC TPI 355, '69 truck 4-bolt, fully balanced, 9.75:1 compression, fully ported '70 truck heads(for now), Harland Sharp 1.6 Roller Rockers, Comp Cams CS 252AH-12, ported '86 TPI converted to speed density, Crane AFPR, Flowmaster 3in. exhaust, Edelbrock TES headers, all emissions equipment is still intact, plan on burning my own chips, many more mods and parts on the way as time and money permits =(
Best E.T. with TBI 305: 16.11 @ 82mph
Haven't been to track with new motor
If you have any questions on converting from TBI to TPI email me at jdkchevy70@yahoo.com
In memory of Dale Earnhardt, I'll miss cheering for that black #3 on raceday!!!
------------------
'88 IROC TPI 355, '69 truck 4-bolt, fully balanced, 9.75:1 compression, fully ported '70 truck heads(for now), Harland Sharp 1.6 Roller Rockers, Comp Cams CS 252AH-12, ported '86 TPI converted to speed density, Crane AFPR, Flowmaster 3in. exhaust, Edelbrock TES headers, all emissions equipment is still intact, plan on burning my own chips, many more mods and parts on the way as time and money permits =(
Best E.T. with TBI 305: 16.11 @ 82mph
Haven't been to track with new motor
If you have any questions on converting from TBI to TPI email me at jdkchevy70@yahoo.com
In memory of Dale Earnhardt, I'll miss cheering for that black #3 on raceday!!!
TGO Supporter
Joined: Jul 1999
Posts: 10,907
Likes: 4
From: The Bone Yard
Car: Death Mobile
Engine: 666 c.i.
Read up on this subject on the DIY PROM board by searching for "MAT". There has been a lot discussed on this subject and I am too lazy to write it all again.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM
IROCZDAVE (88-L98)
Interior Parts for Sale
0
Sep 17, 2015 05:46 PM