Recommended pushrods for Comp 268 XFI HR13
Thread Starter
Joined: Jul 2003
Posts: 2,017
Likes: 13
From: Troup, Texas
Car: 1989 Camaro IROC-Z
Engine: ZZZ# 0607 of 1200 produced
Transmission: Pro-Built 700R4/Vig.2400
Axle/Gears: 3.27 BW 9 Bolt PBR Disc
Recommended pushrods for Comp 268 XFI HR13
Who is running this cam, and what pushrods are you using? I have a pretty standard bottom end 350 ZZZ with the above mentioned cam, afr 180cc heads. Engine builder says my stock length pushrods are too short, recommended 7.400" rods. What is stock length, 7.200"? Any info would be greatly appreciated.
Will
Will
Supreme Member
iTrader: (3)
Joined: Sep 2003
Posts: 6,859
Likes: 14
From: Cypress, California
Car: 1989 GTA
Engine: 369 TPI
Transmission: 4L60E
Axle/Gears: 3.70 Nine Bolt
Re: Recommended pushrods for Comp 268 XFI HR13
Stock is 7.200" for a L-98 roller cam. However depending on the geometry and if he is using mid-lift 7.40" may be correct. Ask him if he is using the mid-lift method.
Thread Starter
Joined: Jul 2003
Posts: 2,017
Likes: 13
From: Troup, Texas
Car: 1989 Camaro IROC-Z
Engine: ZZZ# 0607 of 1200 produced
Transmission: Pro-Built 700R4/Vig.2400
Axle/Gears: 3.27 BW 9 Bolt PBR Disc
Re: Recommended pushrods for Comp 268 XFI HR13
Thanks for the info
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM
no green
Engine/Drivetrain/Suspension Parts for Sale
11
Jan 9, 2016 09:22 PM
