Hey Guys

I know this isn't a performance question but this cruise control issue is very annoying. It's a 92 z28 TPI auto. I have been reading wires out in the column and everthing points to the cruise control module. But I cant seem to find this thing. Does anyone know where this is so I can read the output wires. I am getting no power to the brake switch or the servo. I am getting 12v out from green wire on the turn signal switch that goes to module. So I have to find this thing.

thanks

 

Nevermind I found it.

 

What did it end up being.

 

I still dont know, I replaced the module and servo and it still dont work. Just have to keep reading wires.

 

Ok I found a broken wire pin at the stalk connector behind the little removable cover right behind stalk lever/switch. So I went to radio shack and bought some phone wire butt connectors and hard wired everthing together.
Works like a champ. But I could not have got that far without the help from this site below. The wire schemics were dead on.

http://www.austinthirdgen.org/index.php?pid=19