code 43
Thread Starter
Junior Member
Joined: Jan 2008
Posts: 45
Likes: 0
From: Bellmore Long Island New York Hell yea
Car: 1990 Camaro IROC-Z28
Engine: 5.7L 350cid
Transmission: auto
Axle/Gears: i think 3.42
code 43
so a code 43 is a esc wich i read is only in cars from 85 to 88 iv got a 90 so my problm is the knock sencer but iv have a 74 block with no place to put the sencer waht do i do
Supreme Member
Joined: Jan 2003
Posts: 2,043
Likes: 3
From: San Diego
Car: 1994 Trans Am
Engine: LT1
Transmission: Auto
Axle/Gears: 3.23
Re: code 43
Thats a tough one, I'm sure hope someone with more experience will chime in and point you in the right direction.
I'm sure you don't need a Knock sensor if you only plan on daily driving it and not modding it too much. You could maybe have it tuned out. Maybe in the meantime, run a couple degrees less timing. Base is 6* which is good, put it down to 4* to be safe??
Good luck, sorry I'm not any more help.
I'm sure you don't need a Knock sensor if you only plan on daily driving it and not modding it too much. You could maybe have it tuned out. Maybe in the meantime, run a couple degrees less timing. Base is 6* which is good, put it down to 4* to be safe??
Good luck, sorry I'm not any more help.
Thread
Thread Starter
Forum
Replies
Last Post