TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Help with my 91'

Old Jul 6, 2010 | 04:15 AM
  #1  
CamaroGuy101's Avatar
Thread Starter
Junior Member
 
Joined: Jul 2010
Posts: 7
Likes: 0
From: Rock Hill, South Carolina
Car: 1991 Z28
Engine: 305 TPI
Transmission: 700 r4
Help with my 91'

Im new to the site and was just wondering if anyone had a few suggestions for me.
I have a 91 z28 305 tpi and im just wanting to make it faster basically
Any upgrade suggestions to help me along?
So far im looking into doing a cold air intake, bolt on headers and a super chip
Maybe one of you more experienced guys can give me a hand with some info?
Reply
Old Jul 7, 2010 | 12:57 PM
  #2  
John 89 Formula's Avatar
Senior Member
 
Joined: Jul 1999
Posts: 853
Likes: 0
From: Everett, MA . USA
Car: 89 FORMULA FIREBIRD, 86 CHEVY CAMARO
Engine: L98, LB9 RESPECTIVLY
Transmission: 700 R4 (BOTH)
Re: Help with my 91'

Headers and full exhaust, is always a good place to start. Also, just something to think about, for the cost of a super chip you can buy all the stuff and learn to burn your own.
Reply
Old Jul 7, 2010 | 01:24 PM
  #3  
MrPink's Avatar
Junior Member
iTrader: (6)
 
Joined: Jul 2006
Posts: 92
Likes: 0
From: Castle Rock, Colorado
Car: 1991 Pontiac Trans Am
Engine: 305 TPI 5.0L
Transmission: 700R4
Axle/Gears: 2.73
Re: Help with my 91'

Edlebrock exhaust manifold and tpi runners will give you almost 20 HP over stock. It's the most HP gain you can get for the money. About $700. This combined with a full exhaust upgrade (headers, ypipe, cat back) should give you about 25-30HP total over stock. Everything else you do will be small potatoes unless you start switching out heads and cam.
Reply
Old Jul 8, 2010 | 06:33 PM
  #4  
CamaroGuy101's Avatar
Thread Starter
Junior Member
 
Joined: Jul 2010
Posts: 7
Likes: 0
From: Rock Hill, South Carolina
Car: 1991 Z28
Engine: 305 TPI
Transmission: 700 r4
Re: Help with my 91'

Thanks guys, thats exactly what i was looking for. im not looking to do any real deep engine work like cams and stuff, just simple stuff. Thanks again!
Reply


Thread Tools
Search this Thread

All times are GMT -5. The time now is 10:08 PM.