valve lash
Thread Starter
Member
Joined: Jun 2014
Posts: 393
Likes: 2
From: Montana
Car: 1986 Trans AM WS6
Engine: 383 Vortec TPI, PUTS SMILES ON FACE
Transmission: PATC LVL 3 Raptor Transmission
Axle/Gears: 3.27 POSI 9 BOLT
valve lash
On a 86 305 tpi... I need to do my valve lashing... I want to do it with the engine off... Am still kinda new to valve lashing. Can some one who is experienced in this subject please explains to me the steps.
Thanks.....
I have done research but one those threads theres like 6 ways to do it.
Thanks.....
I have done research but one those threads theres like 6 ways to do it.
Thread Starter
Member
Joined: Jun 2014
Posts: 393
Likes: 2
From: Montana
Car: 1986 Trans AM WS6
Engine: 383 Vortec TPI, PUTS SMILES ON FACE
Transmission: PATC LVL 3 Raptor Transmission
Axle/Gears: 3.27 POSI 9 BOLT
Re: valve lash
Do I go a 1/4 turn after I hit 0 lash
Member
Joined: Jun 2013
Posts: 497
Likes: 4
From: El Sobrante, California
Car: 1984 z28
Engine: Crate replacement L31R 350
Transmission: T56
Axle/Gears: 7.625" 28 spline 3.23
Re: valve lash
I have always used a half turn past zero lash and have never had problems with stock or aftermarket cams.
http://berlinetta.info/Lash.htm
http://berlinetta.info/Lash.htm
Last edited by RamIt; Feb 11, 2015 at 03:49 PM.
Thread
Thread Starter
Forum
Replies
Last Post
355tpipickup
Tech / General Engine
9
Sep 13, 2015 11:35 PM
dimented24x7
Tech / General Engine
4
Sep 6, 2015 03:51 PM