TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Emission delete

Thread Tools
 
Search this Thread
 
Old Apr 10, 2015 | 12:52 AM
  #1  
3rdgenlsx's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2014
Posts: 11
Likes: 0
From: Hamilton ontario
Car: 1991 pontiac trans am Gta
Engine: Lb9 5.0 soon to be L98 5.7
Transmission: 700r4
Axle/Gears: 3.27
Emission delete

Hi I have a 1985 trans am with a l98 tpi from a 1987 corvette I want to remove some stuff to tidy up my engine bay and there is a lot of emission stuff I am from ontario so any car 1987 and under dont need a emission test so can I remove my emission stuff
Reply
Old Apr 10, 2015 | 06:47 AM
  #2  
killer777's Avatar
Member
 
Joined: Aug 2012
Posts: 155
Likes: 0
From: Fort Wayne, Indiana
Car: 1989 Firebird Trans Am
Engine: 355
Transmission: T56
Re: Emission delete

Are you asking for help on removing them, or what to remove or just stating that you are going to remove it.
Reply
Old Apr 14, 2015 | 06:24 PM
  #3  
85Special's Avatar
Member
 
Joined: Jun 2012
Posts: 104
Likes: 0
From: San Tan Valley, AZ
Car: Silver 1985 IROC-Z
Engine: 350 TPI
Transmission: 700-R4
Re: Emission delete

Smog and cat can go without giving codes. Not sure about egr but I assume it would throw a code.
Reply
Old Apr 17, 2015 | 07:38 AM
  #4  
toronto formula's Avatar
Junior Member
iTrader: (1)
 
Joined: Sep 2010
Posts: 95
Likes: 7
From: Toronto
Car: 89 Firebird Formula
Engine: 383 tpi vortec heads Xr 269 cam
Transmission: 700R4
Axle/Gears: 3.73
Re: Emission delete

Not sure if that year has air pump- but if yes you will probably run lean in closed loop since o2 sensor is expecting air from air pump and not getting it so it will reduce fuel. You will probably need new prom to avoid issue- maybe more experienced guys can give their input

Also, in Ontario apparently moe can pull you over to inspect vehicle and all original smog equipment should be in place even though you don't need a drive clean test. Be sure before you start tearing apart....
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
jaridjohn
Exhaust
14
Oct 5, 2015 07:01 AM
racereese
Tech / General Engine
14
Oct 3, 2015 03:46 PM
djmarch
Tech / General Engine
29
Oct 2, 2015 10:41 PM
mcfastestZ28
Tech / General Engine
1
Oct 1, 2015 11:23 AM




All times are GMT -5. The time now is 04:39 AM.