Question on pro-filer 195 head/ tpi intake fitment
Thread Starter
Junior Member
Joined: Jul 2014
Posts: 7
Likes: 0
From: Cincinnati
Car: 1987 Trans am GTA
Engine: SBC 355 Dart heads
Transmission: 700-r4 2200 stall
Axle/Gears: 3.27
Question on pro-filer 195 head/ tpi intake fitment
I am in the process rebuilding my engine and am trying to pick out heads so i can pick a cam, ect.. I have an edelbrock TPI hi-flow intake and edelbrock runners which i'm porting myself. The heads that i have my eye on are Jegs/Pro-filer 195cc. however the intake port is listed as 1.30 x 2.15 inches on the heads and it recommends a fel-pro 1206 gasket. So the question is has anyone used these heads with the Edelbrock TPI intake? and Is it possible to use a fel-pro 1205 gasket and it still seal?
Last edited by 1987transgta; Jan 18, 2017 at 11:55 AM.
Joined: Feb 2001
Posts: 8,494
Likes: 414
From: Sophia, NC
Car: 2016 Camaro SS + 1986 Z28
Re: Question on pro-filer 195 head/ tpi intake fitment
I looked into that combo a couple years ago, and what I found was you could NOT make it fit without adding material to the base manifold. ....I never really looked beyond that, fwiw.