One for the wiring gurus!!!
Thread Starter
Junior Member
Joined: Nov 2001
Posts: 23
Likes: 0
From: Hinesville, GA, USA
Car: 96 Chevy Silverado
One for the wiring gurus!!!
I am modifying my Monte harness, I need a part number and place where I get the pin extractor for the ECM connector pins. TIA DL
Member
Joined: Jun 2001
Posts: 355
Likes: 0
From: Michigan
SPX Corporation.
Its one of these numbers ( they are all on my receipt):
800-3452233
800-8015420
800-533-5338
FAX:800-578-7375
If I am thinking of the same part you want, then the part number is:
J-33095.
Hope this helps!
Its one of these numbers ( they are all on my receipt):
800-3452233
800-8015420
800-533-5338
FAX:800-578-7375
If I am thinking of the same part you want, then the part number is:
J-33095.
Hope this helps!
Supreme Member
iTrader: (1)
Joined: Feb 2000
Posts: 2,361
Likes: 1
From: Savannah, GA
Car: 1997 Jeep Wrangler
Engine: 4.0L
Transmission: 5 speed
Axle/Gears: 8.8 rear, 4.56 gears, 4:1 transfer
Re: One for the wiring gurus!!!
Originally posted by 84LS creeper
I am modifying my Monte harness, I need a part number and place where I get the pin extractor for the ECM connector pins. TIA DL
I am modifying my Monte harness, I need a part number and place where I get the pin extractor for the ECM connector pins. TIA DL
What's up DL!
I told you where to get those things from, did you go there?
Thread Starter
Junior Member
Joined: Nov 2001
Posts: 23
Likes: 0
From: Hinesville, GA, USA
Car: 96 Chevy Silverado
Thanks rockind78 for the info. And Big Daddy LT1 Milligan, I honestly forgot where you said. I went to Discount over the weekend and no luck. Was it Pep Boys? Thanks for the help!!!
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
3
Jan 9, 2017 04:06 PM