L98 potential with this setup?
Thread Starter
Member
Joined: Oct 2001
Posts: 473
Likes: 0
From: Grinnell, Iowa
L98 potential with this setup?
I know this sounds like an idiot's question, but I'm wanting to know what kinda hp is possible here. I mean, there's only so many mods out there. So bare with me here. Here it goes...
350 tpi
headers, free flow cat, exaust
CAI, all free mods,
Accel 300+ ignition, wires, plugs, coil,
AFPR, 24lb. injectors
scoggin dicky intake, SLP runners, ported plenum,
vortech heads, 1.6 roller rockers,
cam-not sure what yet,
and a custom burnt chip.
this is just what i thought a good combo would be, without spending TOO much cash. It's the late term plans for my car.
What kind of hp would this make? I just dont wanna start buying lots of mods if I'm not gonna end up with something great in the end. I'll probably do it anyways cause I could always add nitrous, but I want to know the power potential of it without the juice.
Thanks for the help. -Brian
350 tpi
headers, free flow cat, exaust
CAI, all free mods,
Accel 300+ ignition, wires, plugs, coil,
AFPR, 24lb. injectors
scoggin dicky intake, SLP runners, ported plenum,
vortech heads, 1.6 roller rockers,
cam-not sure what yet,
and a custom burnt chip.
this is just what i thought a good combo would be, without spending TOO much cash. It's the late term plans for my car.
What kind of hp would this make? I just dont wanna start buying lots of mods if I'm not gonna end up with something great in the end. I'll probably do it anyways cause I could always add nitrous, but I want to know the power potential of it without the juice.
Thanks for the help. -Brian
Supreme Member
Joined: May 2001
Posts: 1,118
Likes: 0
From: Amelia, OH, USA
Get a good deal on a set of used aftermarket heads like twisted edge or whatever they are called then get the lt4 intake and send it to john www.lt1intake.com that would be cheaper and be a lot better for the HP ohh and for the cam you CANT BEAT the lt4 hotcam for the price!!!! and id save $250 and skip the roller rockers
Supreme Member
iTrader: (1)
Joined: Feb 2000
Posts: 2,361
Likes: 1
From: Savannah, GA
Car: 1997 Jeep Wrangler
Engine: 4.0L
Transmission: 5 speed
Axle/Gears: 8.8 rear, 4.56 gears, 4:1 transfer
Originally posted by ImportsRsloths
Get a good deal on a set of used aftermarket heads like twisted edge or whatever they are called then get the lt4 intake and send it to john www.lt1intake.com that would be cheaper and be a lot better for the HP ohh and for the cam you CANT BEAT the lt4 hotcam for the price!!!! and id save $250 and skip the roller rockers
Get a good deal on a set of used aftermarket heads like twisted edge or whatever they are called then get the lt4 intake and send it to john www.lt1intake.com that would be cheaper and be a lot better for the HP ohh and for the cam you CANT BEAT the lt4 hotcam for the price!!!! and id save $250 and skip the roller rockers
Thread
Thread Starter
Forum
Replies
Last Post
