How do you swap a HEI dist to a smaller 87+ one?
04-06-2002, 09:53 AM
#1
Member
Thread Starter
Join Date: Jun 2000
Location: Ft. Worth, TX
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
How do you swap a HEI dist to a smaller 87+ one?
I picked up a 89 TBI dist for $20 w/ the coil and was thinking about swapping it for my HEI one. I don't have any of the pig tails coming off the dist, though. Is it just a direct cut and match the colors from the HEI plug to the smaller dist or is there more to it than that?
04-06-2002, 08:35 PM
#3
Member
Thread Starter
Join Date: Jun 2000
Location: Ft. Worth, TX
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
Thanks, I still need the pigtail that plugs into the five pin side of the modual. Do you know of any place I can get one for a reasonable price ?
Also, On the coil there's 2 places to plug the red/yellow plug that goes to the distributor. I assume these are for the tach/bat and that I need to plug the tach/bat to one side and the other goes to the dist. correct? Some times you just need to see things for youself (too bad I don't know anyone with one).
Also, On the coil there's 2 places to plug the red/yellow plug that goes to the distributor. I assume these are for the tach/bat and that I need to plug the tach/bat to one side and the other goes to the dist. correct? Some times you just need to see things for youself (too bad I don't know anyone with one).
Thread
Thread Starter
Forum
Replies
Last Post