speedo gear replacement
Thread Starter
Junior Member
Joined: Apr 2002
Posts: 5
Likes: 0
speedo gear replacement
This is kind of a non technical question, but there is a clip that holds the drive gear in place, and when I finally got the drive gear removed, the clip went flying accross the floor. My question is that there are two places about an inch apart that the clip can go. Does anyone know whether it goes in the hole closest to the front of the car or the back of the car?
Senior Member
Joined: May 2001
Posts: 745
Likes: 0
From: springfield,IL
Car: T/A / Grand Am
Engine: 383 SBC
Transmission: glide
Axle/Gears: 9" ford 5.67
Re: speedo gear replacement
Originally posted by JKD69350
This is kind of a non technical question, but there is a clip that holds the drive gear in place, and when I finally got the drive gear removed, the clip went flying accross the floor. My question is that there are two places about an inch apart that the clip can go. Does anyone know whether it goes in the hole closest to the front of the car or the back of the car?
This is kind of a non technical question, but there is a clip that holds the drive gear in place, and when I finally got the drive gear removed, the clip went flying accross the floor. My question is that there are two places about an inch apart that the clip can go. Does anyone know whether it goes in the hole closest to the front of the car or the back of the car?
Thread
Thread Starter
Forum
Replies
Last Post
beachrodder
Transmissions and Drivetrain
3
Aug 7, 2015 04:27 PM
