Spohn driveshaft?
Supreme Member
Joined: Nov 2002
Posts: 2,776
Likes: 8
From: Santa Monica, CA
Car: '91 Camaro RS
Engine: F1R Procharged 383
Transmission: Tremec 600
Axle/Gears: moser 12 bolt, 4.11's 33 spline axl
lol, nope but i have that exact same driveshaft.....i had it custom made by the shop that presses bearings and such for me, they are a big driveline shop.
it cost me all of a 170 bucks including the 1350 spicer u-joints. that spohn deal is a waste of money if you ask me. The shaft i had made is the same materials that the spohn one lists on their site, and its lighter than the stock shaft too.
it took about 1/2 day to make it for me, and included balancing.
just have a shop make you one
it cost me all of a 170 bucks including the 1350 spicer u-joints. that spohn deal is a waste of money if you ask me. The shaft i had made is the same materials that the spohn one lists on their site, and its lighter than the stock shaft too.
it took about 1/2 day to make it for me, and included balancing.
just have a shop make you one
Thread
Thread Starter
Forum
Replies
Last Post
darwinprice
Organized Drag Racing and Autocross
17
Oct 11, 2015 11:51 PM
