How to get out gov gear?
Supreme Member
Joined: Sep 2001
Posts: 1,195
Likes: 0
From: Flowery Branch, GA
Car: 1985 Iroc-Z
Engine: 1 BA 305 TPI
Transmission: Probuilt 700R4 - 2800 Stall Midwest
Axle/Gears: 3.42
I replaced mine today. It wasn't too bad. Just use a screwdriver and a hammer to get the cap off and on. Don't hit the center of the cap, only the lips. I had to lower my tranny to make it a little easier to get too. Took about an hour to replace.
Thread Starter
Junior Member
Joined: Sep 2002
Posts: 62
Likes: 0
From: Morton, IL
Originally posted by jfreeman74
I replaced mine today. It wasn't too bad. Just use a screwdriver and a hammer to get the cap off and on. Don't hit the center of the cap, only the lips. I had to lower my tranny to make it a little easier to get too. Took about an hour to replace.
I replaced mine today. It wasn't too bad. Just use a screwdriver and a hammer to get the cap off and on. Don't hit the center of the cap, only the lips. I had to lower my tranny to make it a little easier to get too. Took about an hour to replace.
Thread
Thread Starter
Forum
Replies
Last Post
UltRoadWarrior9
Transmissions and Drivetrain
3
Sep 2, 2015 08:24 PM