I put a holley avenger on my motor bought the holley kickdown stud part# 20-40 and the kickdown cable bracket #20-95 now im clueless the bracket looks like it doesnt hookup any where and the stud is like 1/4 in diameter and dont know where it hooks up on the carb i really need some help i can get sum pics if needed. Also i have the stock intake manifold.

 

The 20-95 bracket bolts to the carburator flange over the left rear stud...however, I seem to recall that the offset is wrong. I use a factory GM bracket off of any Carburated LG4 Camaro\Firebird and it works better than the Holley piece.

The 20-40 stud is correct. Edit: There is a projection at the very bottom of the throttle linkage with about a 3\16" hole. You may have to file out the hole slightly to fit the 20-40 stud. Cable goes there and just snaps on stud. You must use a kickdown cable off of an 1982 thru 1986 carburated LG4 car ( FI cable different ). Then it will work.

 

Here is a picture of my Holley on my 350 motor. Car was origianlly a 1986 LG4. Note the position of the the throttle cable. Just beside where I have my lower throttle return spring located, is where the TV cable stud goes. In fact the stud for the TV cable is still installed...even though I have a 5 speed now.

 

oh thanks i put the return spring where the sutd is supposed to go .

 

ok i have the same bracket as you from an 84 lg4 but my big problem is the kickdown cable is too short and cant figure out how to adjust it?

oh yea that $20 holley bracket is garbage.

 

I got it thanks again for the info.