how to remove torque arm
Thread Starter
Joined: Jul 2002
Posts: 2,789
Likes: 0
From: NOR CAL USA
Car: 89 iroc-z 5.7tpi 350,
Engine: 5.7tpi 350,
Transmission: T-56
how to remove torque arm
ok...i am finishing up my t-56 swap in my 89 iroc i have the 700r4 dropped...out...and when i went to go remove the torque arem from the rear end...the studs i wanna say would just turn not the bolt on the stud??? how do i remove it?? i bought the spohn crossmember/toruqe arm for t-56
Supreme Member
iTrader: (1)
Joined: Apr 2000
Posts: 5,321
Likes: 4
From: Northern CA.
Car: '82 Z28
Engine: 350
Transmission: TH400 4,000 stall
Axle/Gears: Currie 9", 4.56 gears
Put a wrench on the other end? Might be covered in years of grease build up and you can't see the top. It's just a big *** bolt with a nut on the end if this is what you're talking about.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
Apr 25, 2016 09:21 PM
