Speedo Drive gear question
Thread Starter
Supreme Member
Joined: Mar 2005
Posts: 1,121
Likes: 0
From: Spicer, MN
Car: '83 Berli, '84 Berli, '84 Z28 HO
Engine: L69, LG4, L69
Transmission: TH700-R4, TH700-R4, T-5
Axle/Gears: 3.08, 3.08, 3.73 Posi
Speedo Drive gear question
Odd question. But will the drive and driven gears from a th350 work in a t-5?
the teeth count does not matter to me at all. since i have a digital dash in the car now that will calibrate to use any drive gear ratio for the speedo gears.. I just need to know if the gears in the th350 will successfully work in a t-5 tranny. along with the sleeve..
the teeth count does not matter to me at all. since i have a digital dash in the car now that will calibrate to use any drive gear ratio for the speedo gears.. I just need to know if the gears in the th350 will successfully work in a t-5 tranny. along with the sleeve..
Member
Joined: Aug 2004
Posts: 298
Likes: 1
From: Miami, FL
Car: '85 TA
Engine: Carb'd 350, ported 416s
Transmission: retrofitted T5
Axle/Gears: 3.42 7.62" 10-bolt, locker
from the gears i have seen, the ones from automatic cars are about an inch in diameter, whereas the ones from a t5 are about 3/8 of an inch in diameter. maybe if you had a big hammer...
Thread Starter
Supreme Member
Joined: Mar 2005
Posts: 1,121
Likes: 0
From: Spicer, MN
Car: '83 Berli, '84 Berli, '84 Z28 HO
Engine: L69, LG4, L69
Transmission: TH700-R4, TH700-R4, T-5
Axle/Gears: 3.08, 3.08, 3.73 Posi
ahh ok.. that explains that for me. i have never had a tranny apart to know
Thread
Thread Starter
Forum
Replies
Last Post
beachrodder
Transmissions and Drivetrain
3
Aug 7, 2015 04:27 PM