bmr torque arm with 3 inch driveshaft
Thread Starter
Junior Member
Joined: Jul 2002
Posts: 66
Likes: 0
From: sc
bmr torque arm with 3 inch driveshaft
anyone running the bmr i think its the trak pak torque arm the shorter one with the weld in crossmember i got all this welded in when i got the cage and subframe connectors on it and i havent got the car back together yet (ran out of money) and its looking like its gonna be close with the driveshaft its a 3 inch aluminum one. i was wondering if anyone has had a set up like this yet to see if i am gonna have any probs b4 i get into it
Joined: Jul 1999
Posts: 394
Likes: 0
From: illinois
Car: 86 camaro
Engine: 433 big block
Transmission: jw powerglide 5500 coan stall
Axle/Gears: moser9" 4:11 posi
i'm using the bmr torque arm and don't have any clearence problems with a 3 inch steel driveshaft. thats a good torque arm ,you'll like it.
Thread
Thread Starter
Forum
Replies
Last Post
Ragtop Man
Transmissions and Drivetrain
2
Sep 12, 2015 12:23 AM
