Transmission and engine not properly bolted
Thread Starter
Member
Joined: Jan 2006
Posts: 113
Likes: 1
Car: 1988 Camaro SC
Engine: 2.8v6
Transmission: 5spd manual
Transmission and engine not properly bolted
I was performing an oil change the other day and noticed the transmission and the engine were not completely joined together.
When i park there is a spotty line of oil right in the middle of the two.
Where can i get more bolts, what are they called and where from?
Is the black oil I see, more likely tranny fluid or engine oil?
All input appreciated...thanks!!!
When i park there is a spotty line of oil right in the middle of the two.
Where can i get more bolts, what are they called and where from?
Is the black oil I see, more likely tranny fluid or engine oil?
All input appreciated...thanks!!!
Member
iTrader: (2)
Joined: Dec 2005
Posts: 289
Likes: 0
From: Cinnaminson, NJ
Car: 90 IROC-Z
Engine: 350 TPI
Re: Transmission and engine not properly bolted
are you sure they arent completely together? if that were the case i'm pretty sure your car wouldnt go anywhere. what youre probably seeing is the black plastic thing that goes over the tranny, that doesnt sit flush with the motor.
Thread
Thread Starter
Forum
Replies
Last Post




