we have a 85 corvette that had the doug nash 4 + 3 in it and the reverse crapped out so we decided to put the t-56 in it. we have all the parts we need to finish the job EXCEPT one! we bought the clutch master & slave cylinder (for 93 camaro) but we are not able to locate the line that goes between them. i contacted GM and they state that they only sell it as a 3 piece set (master, slave and line) and it will cost me almost 3 times as much as i have already paid. any ideas on what we can do or where we can get what we need? i contacted mcleod and they said because it is a custom job that it would cost a minimum of $100 plus shipping.

 

When I got mine I just bought the whole thing from GM. I think it was around $100 and was already pre-blead. I think you may be able to get just the line but I can't remember where.

 

i tried getting just the line from GM and they dont sell it seperatly. I have to buy all 3 pieces, so I guess thats what I am going to have to do!

 

i absolutly couldnt find the line around here, scoured the bone yards and all they had were automatics or just the frames. i even went to a hydraulics company to see if they could make one for me. i ended up finding the 3 part set from a company in arizona, $149 shipped, should be here in 2 days. thanks for the advice!!