Aluminum driveshaft
Joined: Aug 1999
Posts: 19,282
Likes: 103
From: Lawrence, KS
Car: Met. Silver 85 IROC/Sold
Engine: 350 HO Deluxe (350ci/330hp)
Transmission: T-5 (Non-WC)
Axle/Gears: Limited Slip 3.23's
Yes, it'll fit. I've sold thirdgen shafts to several fourthgen owners without problem. Should you be interested I have an 88 Camaro alum shaft for sale, $155 shipped (I also have an 89 which needs to be balanced, $65--or best offer--shipped).
JamesC
------------------
JamesC
------------------
Supreme Member
Joined: Jul 1999
Posts: 2,767
Likes: 2
From: Vereinigten Staaten
Car: Take
Engine: Your
Transmission: Pick
In case you needed a second opinion, Yes, it will. (not that anybody should doubt you, James, but there is strenght in numbers!)
------------------
<marquee type=slide>
If you live in Southeastern US, check us out!
South East Thirdgen
</marquee>
"I used to have a handle on life, but then I used it as a plunger and broke it" -The Wave
ASE Master Tech + L1
Savannah, GA
'87 Trans Am-K&N,Cold air induction, SSM SFC, Boxed LCAs, 8mm Accel wires, Flowmaster, 16" GTA rims.
'97 Bonneville SSE
[This message has been edited by GMTech (edited September 24, 2000).]
------------------
<marquee type=slide>
If you live in Southeastern US, check us out!
South East Thirdgen
</marquee>
"I used to have a handle on life, but then I used it as a plunger and broke it" -The Wave
ASE Master Tech + L1
Savannah, GA
'87 Trans Am-K&N,Cold air induction, SSM SFC, Boxed LCAs, 8mm Accel wires, Flowmaster, 16" GTA rims.
'97 Bonneville SSE
[This message has been edited by GMTech (edited September 24, 2000).]
Thread
Thread Starter
Forum
Replies
Last Post







