question about getting the govener back in

Reply Subscribe

Thread Tools

Search this Thread

Dec 5, 2001 | 06:51 PM

84blackbeast

Thread Starter

Junior Member

Joined: Jan 2001

Posts: 13

Likes: 0

From: oklahoma

question about getting the govener back in

i pulled the govener out to replace the gear because it broke.I got the gear on good.I just cant figure out how to get the govener back in.My car is off the ground in neutral.plez help im in a hurry to get this done tonight...thanx

Dec 5, 2001 | 07:16 PM

84blackbeast

Thread Starter

Junior Member

Joined: Jan 2001

Posts: 13

Likes: 0

From: oklahoma

do I pull the shaft or is there a way to push the govoner back in while the someone turns the wheels?IM new at this so i kinda new some advice.thanx

Dec 5, 2001 | 07:21 PM

GMTech

Supreme Member

Joined: Jul 1999

Posts: 2,767

Likes: 2

From: Vereinigten Staaten

Car: Take

Engine: Your

Transmission: Pick

It should kinda "twist" in place.

------------------
If you live in Southeastern US, check us out!
South East Thirdgen

1987 Trans Am 305
14.88 @ 92.81

Dec 5, 2001 | 07:24 PM

84blackbeast

Thread Starter

Junior Member

Joined: Jan 2001

Posts: 13

Likes: 0

From: oklahoma

it twist a little bit but not enough to get in all the way, cap wont go on.im scared to twist to hard because im not sure if it is supost to be that hard to get in

Dec 5, 2001 | 07:26 PM

GMTech

Supreme Member

Joined: Jul 1999

Posts: 2,767

Likes: 2

From: Vereinigten Staaten

Car: Take

Engine: Your

Transmission: Pick

You put a similar gear on correct? You can try putting the tranny in Neutral and turning the driveshaft.

------------------
If you live in Southeastern US, check us out!
South East Thirdgen

1987 Trans Am 305
14.88 @ 92.81