Shift Cable Bracket
Thread Starter
Junior Member
Joined: Mar 2010
Posts: 5
Likes: 0
From: North Carolina
Car: 82 Trans Am
Engine: 305 TBI
Transmission: Auto :(
Axle/Gears: Whatever is stock
Shift Cable Bracket
Alright then, I'm honestly confused on this one, usually I can find my problem by searching, this one hasn't come up yet. I'm under my car almost literally typing this too. My shift cable refuses to go back up the automatic tree. It will go down fine and dandy. The cable is still attached and adjusted properly, since I just adjusted it. The problem is that the cable doesn't stay in the bracket. Any suggestions on this one?
Joined: May 2009
Posts: 4,915
Likes: 40
From: Far West
Car: 1986 Camaro Z28 IROC-Z
Engine: 350 Tuned Port Injection, for now.
Transmission: 700R4
Axle/Gears: Posi - 3.23
Re: Shift Cable Bracket
Make sure its sitting inside the bracket so that it doesnt come out.
Joined: May 2009
Posts: 4,915
Likes: 40
From: Far West
Car: 1986 Camaro Z28 IROC-Z
Engine: 350 Tuned Port Injection, for now.
Transmission: 700R4
Axle/Gears: Posi - 3.23
Re: Shift Cable Bracket
also take a picture to better clarify your question.
Thread Starter
Junior Member
Joined: Mar 2010
Posts: 5
Likes: 0
From: North Carolina
Car: 82 Trans Am
Engine: 305 TBI
Transmission: Auto :(
Axle/Gears: Whatever is stock
Re: Shift Cable Bracket
It's good, I figured it out. The rubber piece had slid down the cable and wasn't sitting where it should have been.
Thread
Thread Starter
Forum
Replies
Last Post
TheTraut88
Engine/Drivetrain/Suspension Parts for Sale
1
Sep 7, 2015 05:22 PM
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
Sep 2, 2015 08:49 AM
