HELP corvette servo snapring
Thread Starter
Member
Joined: Sep 2007
Posts: 322
Likes: 1
From: Bastrop, Tx
Car: 87 Iroc-Z
Engine: 305 tpi
Transmission: 700-r4
Axle/Gears: 3.42
HELP corvette servo snapring
I just put in a corvette servo and cannot get the snapring back in. I thought I had it yesterday but it popped out and trans fluid everywhere. I've been trying to do it by getting one end in and then going around trying to get the rest in but no go. Any tips or tools I can buy to make this easier
Joined: Aug 2006
Posts: 12,803
Likes: 103
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: HELP corvette servo snapring
can you wedge something along the side of the tunnel and push the cover in while you try to install the ring?
Thread Starter
Member
Joined: Sep 2007
Posts: 322
Likes: 1
From: Bastrop, Tx
Car: 87 Iroc-Z
Engine: 305 tpi
Transmission: 700-r4
Axle/Gears: 3.42
Re: HELP corvette servo snapring
I finally got it in i just pinned one end into the grove with a screw driver and my bro put the other side in. Best mod ever (corvette servo and governor) it shifts amazing very smooth at low speeds but strong firm positive shifts when on the throttle.
Thread
Thread Starter
Forum
Replies
Last Post
the_hamturdler
Engine/Drivetrain/Suspension Parts for Sale
0
Sep 30, 2015 12:50 PM
Dragonsys
Engine/Drivetrain/Suspension Parts for Sale
2
Sep 25, 2015 03:51 PM
