3.5" custom driveshaft clearance
Thread Starter
Senior Member
iTrader: (3)
Joined: Jul 1999
Posts: 844
Likes: 0
From: Long Island, NY
Car: 1987 GTA
Engine: 645hp/656 ft lb Blown 383
Transmission: 700-R4 3,000 stall
Axle/Gears: 3.55 moser 12-bolt
3.5" custom driveshaft clearance
I'm having a 3.5" custom driveshaft made by Supershafts on long island.
I just ordered it today, but I am wondering if it will clear the torque arm and whatnot.
Anyone have any input?
I just ordered it today, but I am wondering if it will clear the torque arm and whatnot.
Anyone have any input?
Supreme Member
iTrader: (7)
Joined: Jul 2000
Posts: 2,047
Likes: 2
From: Prince George, BC, Canada
Car: 89 GTA
Engine: 5.7L Supercharged
Transmission: T-56
Axle/Gears: Moser 9" 3.70
Re: 3.5" custom driveshaft clearance
I use 4" one myself that was locally built, though I have a Spohn torque arm in the stock location.
Joined: Aug 2006
Posts: 12,807
Likes: 108
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: 3.5" custom driveshaft clearance
Clearance is fine. Only issue I ever had was with a lowered car and the rear not ce ter right and the shaft rubbed on the parking brake braket and cut a ring into the shaft
Thread Starter
Senior Member
iTrader: (3)
Joined: Jul 1999
Posts: 844
Likes: 0
From: Long Island, NY
Car: 1987 GTA
Engine: 645hp/656 ft lb Blown 383
Transmission: 700-R4 3,000 stall
Axle/Gears: 3.55 moser 12-bolt
Re: 3.5" custom driveshaft clearance
good info thanks
I also have 4" exhaust but i think that will be fine or i will move it
I also have 4" exhaust but i think that will be fine or i will move it
Supreme Member
iTrader: (7)
Joined: Jul 2000
Posts: 2,047
Likes: 2
From: Prince George, BC, Canada
Car: 89 GTA
Engine: 5.7L Supercharged
Transmission: T-56
Axle/Gears: Moser 9" 3.70
Re: 3.5" custom driveshaft clearance
I also have a 4" exhaust, no problems there either.
Thread
Thread Starter
Forum
Replies
Last Post