10" clutch???
Thread Starter
Joined: Jun 2000
Posts: 5,364
Likes: 51
From: Enschede, Netherlands
Car: 82 TA 87 IZ L98 88 IZ LB9 88 IZ L98
Engine: 5.7TBI 5,7TPI 5.0TPI, 5,7TPI
Transmission: T5, 700R4, T5, 700R4
Axle/Gears: 3.08, 3.27, 3.45, 3.27
10" clutch???
OK, stupid question here... have a centerforce billet fw, I thought it was for a t5 but it is not, it's the correct tooth, 1pc main, ext balanced rear...all checks out...but the bolt pattern. The bolt circle for the PP is at about 10.5 so no way a 10.4 clutch and pp are gonna fit without redrilling
Anyone know what kind of pp and disc this was intended for?
here next to oem fw that idiot coater powdercoated (he was told to just blast it... now it makes for wall art)
Anyone know what kind of pp and disc this was intended for?
here next to oem fw that idiot coater powdercoated (he was told to just blast it... now it makes for wall art)
Thread Starter
Joined: Jun 2000
Posts: 5,364
Likes: 51
From: Enschede, Netherlands
Car: 82 TA 87 IZ L98 88 IZ LB9 88 IZ L98
Engine: 5.7TBI 5,7TPI 5.0TPI, 5,7TPI
Transmission: T5, 700R4, T5, 700R4
Axle/Gears: 3.08, 3.27, 3.45, 3.27
Re: 10" clutch???
Looks like ford uses 10" clutches so possibly it was for a conversion using a ford transmission behind an SBC. I have 2 options, redrill the flywheel or run a 10 inch ford clutch with 26 splines (they are available)... ugh.
Joined: Jul 2000
Posts: 6,521
Likes: 91
From: Aridzona
Car: `86 SS / `87 SS
Engine: L69 w/ TPI on top / 305 4bbl
Transmission: `95 T56 \ `88 200-4R
Re: 10" clutch???
Lots of guys worry about not being able to run an 11" clutch when only a10.5" will fit. You'll be fine.
On the bright side, it's available in 26 spline, not just 10!
On the bright side, it's available in 26 spline, not just 10!
Last edited by jmd; Dec 16, 2015 at 05:37 PM.
Thread Starter
Joined: Jun 2000
Posts: 5,364
Likes: 51
From: Enschede, Netherlands
Car: 82 TA 87 IZ L98 88 IZ LB9 88 IZ L98
Engine: 5.7TBI 5,7TPI 5.0TPI, 5,7TPI
Transmission: T5, 700R4, T5, 700R4
Axle/Gears: 3.08, 3.27, 3.45, 3.27
Re: 10" clutch???
Only a 10" clutch will fit but I have a brand new centerforce clutch and pressure plate. I think drilling 6 holes is the cheapest and best route
Thread
Thread Starter
Forum
Replies
Last Post
L98IROCZ89
Transmissions and Drivetrain
2
Sep 2, 2002 06:39 PM
mult68
Tech / General Engine
2
Jan 3, 2002 12:58 AM