Hey everyone, getting the loose ends on my 700r4 rebuild together, and I've run into a question I just can not find the answer to.. I installed the Sonnax pinless accumulators in the 1-2 and 3-4, and I just got the transgo jr correction kit. I can't seem to find any information on if these springs will work with those accumulators.. I've installed a bunch of other stuffs; .500 b/v, .296 l/r boost valve, alto heg HD clutches, 3-4 Alto heg power pack, red alto wide Kevlar band. Have yet to rebuild my pump with the hardened rings. Think I may have left out a thick steel in the 3-4... Oops. Trans is back in the truck but I can take it out at my sister's place. (yes it's a truck) (but it thinks it's a corvette) (: oh.. And I have a corvette servo to install, that showed up yesterday, do I need the governor to match is is that even necessary? I appreciate your help and advice. I've followed this forum for a looong time and being only 23, I have learned alooot from here.