I've just replaced the carrier and pinion bearings in my BW 9-bolt rear end. This is the first time I'm doing this so I'm hoping that you guys can have a look at this gear pattern and tell me what you think.
Backlash is set to 0.007". Keep in mind that these gears are not new.
Backlash is set to 0.007". Keep in mind that these gears are not new.
Supreme Member
Looks like the pinion is a little deep, but it would probably run fine like this. If it was me I'd take about .003 out of the pinion shim and check it again.
NoEmissions84TA
Supreme Member
close
Today
- Join DateFeb 2017
- LocationMeriden, CT 06451
- Posts:4,185
- iTrader Positive Feedback100
- iTrader Feedback Score(1)
- Car84 TA orig. 305 LG4 "H" E4ME
- Engine334 SBC - stroked 305 M4ME Q-Jet
- Transmissionupgraded 700R4 3200 stall
- Axle/Gears10bolt 4.10 Posi w Lakewood TA Bars
- Likes:1,764
- Liked:576 Times in 476 Posts
These should help you decide.
