I am looking for a few good pictures of where the clutch slave cylinder is mounted on the firewall. I have a wildwood hyd clutch setup going into my 86 iroc.

Thank you

Fran

 

These pics show a T5 swap: The T56 tunnel hole needs to be a little bigger IIRC,.... ( Been awhile, but I think it needs a little more cut from the front of the hole? )

Temp Install the pedals and push the side braces against the firewall HARD,.... mark the holes. These holes are CRITICAL to getting the hydraulics mounted in the correct position.

* Notice I cut-off the firewall stud for retaining the PARK LOCK cable.......

Hydraulics holes:








Floor hole:




Good luck !

 

great pictures, Thank You.