V6 Discussion and questions about the base carbureted or MPFI V6's and the rare SFI Turbo V6.

low blms what gives? need help

Old Apr 30, 2002 | 10:17 PM
  #1  
jester111's Avatar
Thread Starter
Member
 
Joined: Nov 2001
Posts: 122
Likes: 0
low blms what gives? need help

hey guys
At idle and when the car warms up the blm is about 100. The car does idle a little rough, but no hesitation or miss.
checked fuel press ign. on 41 psi, at idle 37 psi, and idle vacum disconnected 44 psi. Pinched return hoes and jumps to 75psi+.
Fuel press reg hold vacum and is not leaking. Fuel press reg. vacum source is approx. 18 inches. Evap is not purging at idle, no change with evap disconnected.
I did get a code 33 high circuit voltage but i think its a false code because map is in range.
O2 crosscounts are very low and slow so O2 is probably shot.
Theres also about 225K on the motor.
I did perform a injector flush yesterday and engine does seem to run better while driving but not when idling. If the injectors were to leak down then it would cause a hard start problem right, it starts fine cold and hot.
any ideas or suggestion will be greatly appriciated!!!!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
antman89iroc
DIY PROM
36
Jan 31, 2016 08:42 AM
BrianI
Tech / General Engine
2
Oct 3, 2015 12:57 PM
Giocio
TBI
7
Oct 1, 2015 12:20 PM
Damon
Tech / General Engine
8
Sep 26, 2015 04:29 PM
ULTM8Z
DIY PROM
1
Sep 16, 2015 09:15 AM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 11:51 AM.