pics of the almost done engine bay. I expect to crank it over tonight!!!!!!!!
http://www.thenebula.com/carpics/pics/almost1.jpg

http://www.thenebula.com/carpics/pics/almost2.jpg

http://www.thenebula.com/carpics/pics/almost3.jpg

http://www.thenebula.com/carpics/pics/almost4.jpg

add radiator, water/coolant, hookup hoses & tranny lines. add power steering fluid.

hold ears, turn over. play w/distributor to keep running.

 

Its looking good.
This project is really coming together.

 

LOOKS SENSATIONAL!
My Blazer 3.4 motor is at same stage. Did my valve adjustment last week & got 150 PSI per cylinder I am so pleased with that high reading.
Rains gone, warm weather, only hope my sprained shoulder holds out to wrap up my 2.8->3.4 Swap Boogie Blazer project.
I am so anxious to drive my moving Blazer again..... (no fun driving it in this current stationary stage!)

 

got batt carged, & cranked it...........
......
.....
......
.....
.....
.
.
.
.
.
.
.
.
.
.
.
.wait for it
.
.
.
.
.
.
.
backfire on mpfi is interesting

think I'll go back & verify that #1 tdc location again

am still going to have open manifolds , will put headers on when tranny dies & needs rebuild. more room to work then , will also be registered & **** e-checked

 

ignore

 

You're off a tooth or you're off 180* on distb install.
Be patient You'll make it happen.
You did line new chain up dot to dot right?
Backfire=spark happening wrong time
Hope the new timing chain went on correct!