95 LT1 drive shaft.
Thread Starter
Supreme Member
iTrader: (1)
Joined: Feb 2004
Posts: 1,040
Likes: 1
From: High plains of NM
Car: 89 Firebird
Engine: L98
Transmission: T-56
Axle/Gears: 3.73
95 LT1 drive shaft.
I was thinking about getting one, to replace the old rusted orignal.
Are they much stronger than the steel ones?
Did the factory do any ballancing on them?
I know there only about 2lb lighter.
And why do they all ways break near the rear end yoke?
I allways see them broken some where in the back half. Or even snaped at the rear yoke.
Are they much stronger than the steel ones?
Did the factory do any ballancing on them?
I know there only about 2lb lighter.
And why do they all ways break near the rear end yoke?
I allways see them broken some where in the back half. Or even snaped at the rear yoke.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
Engine/Drivetrain/Suspension Parts for Sale
1
Aug 8, 2015 08:16 PM