V6 Discussion and questions about the base carbureted or MPFI V6's and the rare SFI Turbo V6.

Fan not working

Thread Tools
 
Search this Thread
 
Old Apr 17, 2007 | 08:50 AM
  #1  
xbcrguy182x's Avatar
Thread Starter
Member
 
Joined: Sep 2006
Posts: 287
Likes: 0
From: Brooklyn,NY
Fan not working

Hi everyone, the heat/ac fan never worked on my car when I bought it. When I turn on either the AC, heat or vent, I hear some clicking sounds and a hissing noise for 10 seconds and thats it. No air blowing out. Even if I adjust the speed, nothing happens. Btw, its a 86 firebird with 2.8 v6. Any suggestions? Thanks in advance.
Reply
Old Apr 17, 2007 | 09:23 AM
  #2  
2_point8_boy's Avatar
Supreme Member
 
Joined: Nov 2002
Posts: 1,832
Likes: 1
From: Castaic, CA
Car: 1988 Camaro RS
Engine: 2.8L of Raw POWER!!!
Transmission: Stick Shift
Axle/Gears: 3.42's
Re: Fan not working

There is a resistor pack on the fan housing under the hood, you'll have to make sure that the pack is getting a power signal from the switch inside and make sure the fan's ground is good.

Most of the time when there's an in-op blower motor, it's the resistor pack that's gone bad, but you'll have to check before you replace it.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
2
Dec 16, 2024 01:50 PM
RazorN8
Tech / General Engine
4
Jan 7, 2022 11:44 AM
sweet_87_iroc
Exterior Parts for Sale
7
Mar 27, 2016 04:05 PM
TA8487
Engine/Drivetrain/Suspension Wanted
1
Aug 16, 2015 12:21 PM
Leggman1
Transmissions and Drivetrain
3
Aug 6, 2015 04:15 AM




All times are GMT -5. The time now is 04:55 AM.