Ballast required for Mallory Hyfire 6A?
Thread Starter
Banned
iTrader: (2)
Joined: Mar 2008
Posts: 135
Likes: 0
From: Colorado
Car: 1985 Camaro Sport Coupe
Engine: 2.8 - Bored/Stroked, Pacesetters
Transmission: 5 spd Manual
Axle/Gears: Stock
Ballast required for Mallory Hyfire 6A?
Kinda new with this.....can anyone tell me if a ballast is required for a Mallory Hyfire 6A ignition controller? 1985 2.8L with FI.
Didn't have one previously and the ignition box fried. Now, with the ballast installed, the controller will only turn on (with the ignition on) and unplugging the 2 wire connector to the dizzy and then plugging it back in. Then presto, power to ignition controller. Triple checked the wiring and it's correct. Stumped here!
Any help is appreciated!
Didn't have one previously and the ignition box fried. Now, with the ballast installed, the controller will only turn on (with the ignition on) and unplugging the 2 wire connector to the dizzy and then plugging it back in. Then presto, power to ignition controller. Triple checked the wiring and it's correct. Stumped here!
Any help is appreciated!
Thread
Thread Starter
Forum
Replies
Last Post
ZZ3Astro
Power Adders
1045
Aug 13, 2019 12:57 AM
2012sergen11
Engine/Drivetrain/Suspension Wanted
6
Oct 13, 2015 07:38 PM
