Does anybody know what the name is for this piece. It desintigrated and i have to replace it. The engine is a 2,8l mpfi.

thats just a heater hose pipe unfortunatly u cant buy those anymore.

those 2 pipes that come off the big one run up to the throttle body to heat the bottom of it so the throttle dont stick closed in the winter

unless u live were its like 15* or lower in the winter u dont have to hook those up


what u can do is goto the parts store and get a barbed heater hose fitting, it will have pipe threads on one side and a barbed fitting for clamping a hose on the other end.

to use it just remove the fitting out of the intake and replace it with the new fitting and get a longer hose to connect from there to the heater core up on the firewall

That is pretty much what I did, its 1/2" pipe thread fitting if memory serves, I am sure about the pipe thread but don't take my recollection for perfect as far as what size it was.

And any part store would have this?

I did the same thing that project89 is saying. Got the parts at napa. Cost very little.

This is how it turned out.

yup thats the normal repair, if the hose turns to tight u can goto the hardware store and get a 2 inch 1/2inch pipe nipple that will screw into the intake then u screw a 90 fitting on the end of that, then u screw the brass hose barb onto that and reconect the hose.

looks liek u dont have an issue with the hose collapsing though so u should be good just the way u have it

Looks just like mine although I reused a 90 degree bend hose