My Post Pictures

October 30, 2019

451

0

0 2022/07/10 11:23:01 thainglo

#2 Exhaust - the offending culprit. As can be seen in the picture, the set screw is further down in the hole than the one on the left. Outer nut was only finger tight.

#2 Exhaust - the offending culprit. As can be seen in the picture, the set screw is further down in the hole than the one on the left. Outer nut was only finger tight.

0 2022/07/10 11:34:18 thainglo

Flywheel side of the friction disk. Printing still clearly legible.

Flywheel side of the friction disk. Printing still clearly legible.

0 2022/07/19 14:18:09 thainglo

National PB-656-HD pilot bushing. I have a replacement coming in, thought maybe the marks on the face were from the input shaft. However, I see no corresponding marks on the shaft.

National PB-656-HD pilot bushing. I have a replacement coming in, thought maybe the marks on the face were from the input shaft. However, I see no corresponding marks on the shaft.

0 2022/07/19 14:19:47 thainglo

No markings on input shaft where it fits into bushing. Only about the first two-thirds enters the bushing, judging from the grease line.

No markings on input shaft where it fits into bushing. Only about the first two-thirds enters the bushing, judging from the grease line.

0 2022/07/19 14:22:05 thainglo

Throwout bearing alignment

Throwout bearing alignment

0 2022/07/19 14:23:53 thainglo

0 2022/07/20 14:45:45 thainglo

0 2022/07/20 16:23:05 thainglo

First iteration. Ended up being 10mm to wide as I managed to write down the wrong number on my drawing, despite what my caliper shows. Later design is slimmed down in the width and rear.

First iteration. Ended up being 10mm to wide as I managed to write down the wrong number on my drawing, despite what my caliper shows. Later design is slimmed down in the width and rear.

0 2023/02/10 15:40:00 thainglo

Used brackets from a regular single DIN adapter kit that I had in the attic.

Used brackets from a regular single DIN adapter kit that I had in the attic.

0 2023/02/10 15:40:06 thainglo

Faceplate installed.

Faceplate installed.

0 2023/02/10 15:40:13 thainglo

Page
12 of 12

Go To
Page

Go to page of 12 pages

1
...
6
7
8
9
10
11
12