Here are a couple pictures of Hooker's y-pipe for the 2460 headers. Part number of pipe is 16767. I would have liked it to sit up a bit higher; but it is better than the custom one i had on there! I didn't install the extension piece (that goes in place of the cas) because I am planning on putting the cat. back on. Again, the pipe is 2.5" all around. I will be putting a 3" adaptor onto the end which shouldn't be too difficult.

-Kyle

PS: I only put in 2 out of 3 flange bolts in each side, because i'm taking the pipe back off.

 

and another

 

Looking good

 

How about an overall pic of the pipe out of the car?

 

Here you go five7kid:

 

I was looking at that part #16767 and it says it is for a 1993-1997. Is this correct?

 

Natoric;

This is the part number i used for my 87 Firebird to fit 2460 Hooker headers, and is the correct one. Not sure where you found the 93-97 listing but i believe it to be incorrect.

(See pics of it on my car above)

-Kyle

 

Thanks for the reply. Jegs has it listed for the 1993-1997. Summit has it properly labeled. I appreciate your response.

Nato RC51

 

Topbird where did you buy that from?

 

I ordered it through Keystone at my work (Partsource....same as Advance or Autozone). It took a damn long time to come in but it was over the winter i think so i had my car put away.

-Kyle