CPI install
#1
Junior Member
Thread Starter
Join Date: Jun 2015
Location: vehicle city michigan
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 sc
Engine: 350 tbi on the way
Transmission: t5
Axle/Gears: 3.73
CPI install
So i have a 305 mechanical fuel pump carbed pos. I purchased a 350 4 bolt shitty 193, tbi engine. I also scored a cpi unit and can get the multiple injector upgrade cheap as dirt new as well. But the tbi block doesnt have a mechanical pump spot, my tank only has one line going from it so i believe i need a sending unit, 60 psi pump and to wire the harness in to the chassis. Will a tbi sending unit work? I have a 60 psi pump w/ sending unit but it was out of an old truck and is way to tall for my tank. I figured drop the tank since i plan on dropping rear to change carrier to an lsd unit from a 4th gen and new 3.73s. My biggest concern is the fuel lines/pump. Since its a completely different setup. Any tips or how tos apprecriated
Thread
Thread Starter
Forum
Replies
Last Post