Miniram install question
#1
Supreme Member
Thread Starter
iTrader: (7)
Join Date: Jul 2000
Location: Prince George, BC, Canada
Posts: 2,047
Likes: 0
Received 2 Likes
on
2 Posts
Car: 89 GTA
Engine: 5.7L Supercharged
Transmission: T-56
Axle/Gears: Moser 9" 3.70
Miniram install question
So at the final stages of getting everything in order before I swap out the intake hopefully this week, but I got my intake used so not sure what to do with the IAT sensor. I got the wire that comes with the kit and I imagine it takes the 93+ sensor from looking at the connector but how do I go about hooking this up? Is there a bung that comes with the sensor that I can install in the intake track or something, maybe I can find something at the wreckers?
If any of you guys have pic's or insight on this that would be great
If any of you guys have pic's or insight on this that would be great
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,150
Received 1,693 Likes
on
1,287 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Miniram install question
It works ALOT better to put the sensor out in the air duct somewhere, before the TB.
#3
Senior Member
Re: Miniram install question
In the photo you see a red silicone 90* bend. The IAT sensor is inserted into that piece of silicone. Take your sensor and go to a hardware store to locate the correct size nut to put on it to hold it in place and then drill a hole in the intake duct to insert it in. Periodically check it to make sure it is still tight.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM