Window motor replacement?
#1
Member
Thread Starter
Join Date: May 2005
Location: Goose Creek, SC
Posts: 107
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Trans Am
Engine: 434 being built
Transmission: 700R4
Axle/Gears: 3:73
Window motor replacement???Anybody?
I know someone has a trick to this. My new motor arrived & I'm ready to go! I also need to change the side window glass. I've looked through many pages of threads but not any experienced
responces. I can pick up the heavy duty riveter from NAPA. Reaching to place nut & bolts would be tight. Has anyone bit on this one before? Thanks 87 TA
responces. I can pick up the heavy duty riveter from NAPA. Reaching to place nut & bolts would be tight. Has anyone bit on this one before? Thanks 87 TA
Last edited by Tranny; 07-01-2005 at 10:34 AM.
#2
Member
Join Date: May 2005
Location: Lancashire County, England, UK
Posts: 482
Likes: 0
Received 0 Likes
on
0 Posts
Car: VIN=85 T/A, CAR=82/3 T/A gfx, go figure. She's a T/A anyway!
Engine: 5.0, Holley 600 cfm 4-barrel
Transmission: THM350 ??
I believe you may need to buy some small nuts and bolts which fit in the holes where you drill the rivets out holding the motor to the door skin They are riveted in at the factory, probably due to cost.
Apart from that I haven't had to change one yet! Best of luck
Mark.
Apart from that I haven't had to change one yet! Best of luck
Mark.
#3
Member
Join Date: May 2005
Location: Lancashire County, England, UK
Posts: 482
Likes: 0
Received 0 Likes
on
0 Posts
Car: VIN=85 T/A, CAR=82/3 T/A gfx, go figure. She's a T/A anyway!
Engine: 5.0, Holley 600 cfm 4-barrel
Transmission: THM350 ??
D'OH it's too late here in the UK and I was too tired to understand your post fully before diving in, SORRY!
Mark.
Mark.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM