Question about the aftermarket Aerowing..
01-16-2008, 10:04 AM
#1
Member
Thread Starter
Join Date: Apr 2000
Location: Orlando, FL USA
Posts: 312
Likes: 0
Received 1 Like
on
1 Post
Car: 89 Formula 350
Engine: 5.7 TPI
Transmission: 700R4
Question about the aftermarket Aerowing..
I am planning on replacing the junk factory aerowing on my formula with an aftermarket one form Hawks or G &T, however the metal frames around my hatch glass are severely rusted I picked up some good frames yesterday but they don’t have the 6 metal tabs where the plastic clip hooks into. My question is will the aftermarket aerowing work on hatch frame without the factory metal tabs?
01-17-2008, 07:50 AM
#3
Supreme Member
iTrader: (3)
Join Date: May 2005
Location: Southern IL
Posts: 1,942
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 GTA "Cocaine"
Engine: 350 tpi
Transmission: 700r4
Axle/Gears: 3.27
Re: Question about the aftermarket Aerowing..
glue it down with some two part appoxy
I did it and I think the spoiler will break before the glue
I did it and I think the spoiler will break before the glue
01-17-2008, 11:41 AM
#4
Member
Thread Starter
Join Date: Apr 2000
Location: Orlando, FL USA
Posts: 312
Likes: 0
Received 1 Like
on
1 Post
Car: 89 Formula 350
Engine: 5.7 TPI
Transmission: 700R4
Re: Question about the aftermarket Aerowing..
Yeah, I was thinking if all else fails I will use good 3M double sided tape. I would just like to know what hardware comes with the spoiler.
01-21-2008, 07:40 AM
#5
Member
iTrader: (3)
Join Date: Jun 2005
Location: Ft. Worth
Posts: 472
Likes: 0
Received 0 Likes
on
0 Posts
Re: Question about the aftermarket Aerowing..
Removed comment.
Last edited by net_coma; 01-21-2008 at 08:10 AM. Reason: Read it again and removed comment, thought it was something other than factory replacement.
Thread
Thread Starter
Forum
Replies
Last Post